Publicité
Les langues disponibles
Les langues disponibles
SETTING THE CUTTING HEIGHTS
«
Fig C »
Adjust the cutting height
only when the engine is
switched off and the power
Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners are
damaged. To prevent any imbalance, replace blunt
and/or damaged blades. To carry out this check,
first switch off the motor and pull out the power plug.
To obtain the desired cutting height, the front and
rear axles are repositioned on the underside
of the mower housing.
Disconnect the mower from
the power supply and
ensure the blade has
stopped coasting before
adjusting the height.
> To adjust the front wheel cutting height
position
§ Turn the mower upside down.
§ Pull the wheel axle towards the front of the
mower.
§ Locate the wheel axle into the desired cutting
height adjustment position.
Note: Make sure that both
front right and left wheels
are located in the same
cutting height adjustment
> To adjust the rear wheel cutting height
position
§ Turn the mower on its side.
§ Pull the rear wheel axle towards the mower's
catcher flap.
§ Locate the wheel axle into the desire cutting
height adjustment position.
Note: Make sure that both
rear right and left wheel are
cutting height adjustment
> 3 Cutting height positions
25mm / 45mm / 65 mm
§ 25 mm (lowest cutting height position)
~
§ 65 mm (highest cutting height position)
Important!
cable has been
disconnected.
Warning!
position.
located in the same
position.
OPERATION «
> Connect to power supply.
Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Connect the plug to an extension cable. It is
imperative to secure the extension cable with the
cable grip.
«
> Starting
Fig D »
Press and hold safety button (A) (then squeeze the
switch lever (B) towards the handle).
Release the safety button.
> Stopping
Release the switch lever.
After switching off, the
cutting blade will go on
turning for a few seconds,
make sure the blade has
Do not rapidly switch off
> Safety button
Important! To prevent the machine switching on
accidentally, the lawn mower is equipped with
a safety lock-off which must be pressed before the
switching bar can be activated. The lawn mower
switches itself off when the switch is released.
Repeat this process several times so that you are
sure that the machine functions properly.
Before you perform any repair or maintenance work
on the machine, ensure that the blade is not rotating
and that the power supply is disconnected.
Never open the discharge
flap if the grass bag is being
emptied and the motor is
still running. The rotating
blade can cause serious
Always secure the discharge flap and grass bag
carefully. Always switch off the motor before
you remove these items.
The safety distance between the blade casing and
the user provided by the guide struts must be
maintained at all times.
Fig B & D »
«
Fig B »
ATTENTION :
come to a complete
standstill.
CAUTION:
and on.
Important!
injuries.
39
Publicité
