Télécharger Imprimer la page

Sunjoy A306016801 Mode D'emploi page 18

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY INSTRUCTIONS
10. Slide Reflector Plate onto Reflector Panels.
Insert one Screw M6 x 10 (HH). Slide one Washer
Φ6 (GG) over threaded end of Screw M6 x 10 (HH) and
screw on Cap Nut (II) loosely. Repeat procedure to
complete the assembly of all four sections. Fully tighten
all of the screws in the rolled edge.
11. Support heater. Slide three Washer Φ8 (FF)
over threaded end of spacer. Align the holes in the
Reflector Plate to the 3 Reflector Spacers on the Burner
Assembly. Install three Washers Φ8 on spacers and
securely tighten Wing Nuts (JJ) but do not overtighten.
Hardware Used
FF
JJ
Wing Nut
x 6
x 3
10
II
GG
HH
11
18
JJ
FF

Publicité

loading

Ce manuel est également adapté pour:

Nhss-g-sjgpc