Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
WARNING
This product contain sharp edges on
the panels,cylinder housing and
handle please install with care.
1. . Attach wheel kit (J) to base (K). Line up holes in heel bracket
with corresponding holes in base, insert two bolts M8 x 15 (AA)
through holes, and finger tighten two M8 flange nuts (NN). Reverse
the base (K), fix the ground fixer (LL) to the base with two bolts
M6X10 (CC) and two washers Φ6 (GG), Secure the ground
fixer (LL) with two nuts M6 (MM). Fix another two ground fixer
(LL) with bolts and nuts, and reverse the base (K).
Nails 1981-RTLL for anchoring the base securely to the
ground are not inculded. The Nails must be us
the ground everytime.
Hardware Used
NN
AA
x 2
Bolt M8 x 15
x 6
CC
MM
Bolt M6 X 10
Note: AA NN pre-assembled in J
2. Attach three support brackets (I2) loosely to base with
three bolts M8 x 15 (AA) downward through
support brackets into the Base.
Hardware Used
AA
Bolt
M8 x 15
3. . Install pole onto three support brackets. Atta
pole to support brackets using six bolts M6 x 30 (DD)
& six M6 flange nuts (BB). Fully tighten all of the screws.
Hardware Used
BB
M6 Flange nut
DD
Bolt M6 x 30
GG
x 2
Washers M6
M8 Flange nut
x 6
OO
M6 Nut
Wrench
x 3
x 6
x 6
Note:
x 6
LL
x 3
er
x 1
12
1
AA
K
LL
CC
PP
2
I2
AA
3
DD
BB
NN
J
GG
MM
Publicité
