Publicité
Les langues disponibles
Les langues disponibles
2) How to install the device
The installation template is printed on the packaging.
1/ Unfasten the carton's flaps and place it
against the wall with the lower flap folded
back and resting flat on he floor. Prick out
the four drill holes though the packaging
(without drilling) and then remove the packa-
ging.
2/ Carefully mark the drilling points with a
pencil (draw a cross, 2 cm wide).
3/ Drill the holes.
4/ Screw on and orient the sleeve in place. Fit
the screws with the washers provided.
5/ Screw the pins on the tubes without locking
them. Check they are correctly positioned
by inserting them in the sleeves, with the
device. After finding the right position, tigh-
ten the screws on each pin.
6/ Place the device on the wall, in the sleeves.
Tighten all the locking screws. Fit the caps
on the ends of the pins.
Note: The pins supplied with the device are of the standard
type. In case of a particular stand, use appropriate pins.
B
200 mm
A
Measurement for fitting lugs (mm)
Power
500 W
750 W
1000 W
1500W
1750W
2000W
18
C
200 mm
SOL
A
B
656
320
1066
mini
1599
451
525
861
mini
1394
C
400
386
Publicité
