Kongskilde AIR WASH 50 Manuel D'utilisation page 2

Installation of
the Air Wash
system
• Mount the Air Wash system on
a solid and plane base. Secure
that the Air Wash system is
protected against falling down
upon installation, by mounting
the frame to the base with bolts.
Noise rating
The noise rating is given for an Air
Wash system with MTD 35 blower
(with a 50 Hz rotor for paper). On
the inlet of the cyclone a 1 m
(3.3 ft.) OK200 silencer and a 1 m
(3.3 ft.) OK200 pipe is mounted.
The noise is measured 1 m
(3.3 ft.) from the frame for the Air
Wash system, in the same height
as the diffuser
Position Closed diffuser and cascader
1
dBA 88.6
2
• Do not us the Air Wash system
without the cascades mounted
on the rotary valva, to prevent
contact with the cell wheel
during operation.
• All electrical wiring must be
made by a certified electrician.
Make sure that the direction of
rotation of blower and rotary
valve is correct (see arrow on
Measuring points:
Pos. 1: At the 50 mm (2 in) piping
for the cascades.
Pos. 2: At the suction side of the
cyclone.
Pos. 3: At the outlet side of the
blower.
2 3
83.6 89.9
•
Open diffuser and cascader
1 2 3
90.3 85.5 89.8
blower and rotary valve). If a
hinge is installed for the blower
make sure that the electrical
wire allow the blower to be
turned away from the cyclone.
Always stop the blower and ro-
tary valve prior to maintenance
and repair and avoid uninten-
tional start of the blower and
rotary valve.