Inserting A Microsd Card - Velleman CAMIP23 Mode D'emploi


remote surveillance:
fully compatibility on iPhone
o
medium compatibility on Internet Explorer
o

power supply:
POE (Power Over Ethernet) support to eliminate the use of power cables and reduce
o
installation costs

Note: this product requires a minimum of network installation knowledge
5. Overview
Cables
cable
power cable
RJ45 network cable*
GND
alarm-in
alarm-out
line-in**
line-out**
RESET
for PoE installation, make sure your network cable has the maximum cable resistance of 20 Ω,
*
such as a CAT.5a or CAT.6 cable, to conform the standard of IEEE 802.3af
** for selected models
6.

Inserting a MicroSD Card

Refer to the illustrations on page 2 of this manual.
Using a microSD card allows you to record images and to memorize them. To install/replace the microSD
card:
1. Loosen the screw of the sunshield and slide the sunshield from the camera.
2. Unscrew the front part of the camera to reveal the inner circuit.
3. Remove the two bags of desiccants inside the camera. Remember where and how these were
placed.
4. Remove or place your microSD card.
5. Place the two bags of desiccants inside the camera. To know if the desiccants are good to be used,
hold the bag against a light source. If the desiccants are yellow, you can still use the same bag;
replace the bag with a new one if the desiccants are green or red.
6. Screw the front part onto the camera. Make sure to do this very carefully in order not to damage
the screw thread.
7. Slide the sunshield onto the camera.
Notes

The camera does not support hot-swapping. Insert or remove the microSD card with the power
disconnected.

Any data on the microSD card will be deleted when you insert the card and turn on the camera.

It is recommended to use tweezers, as the camera housing is very narrow.
V. 01 – 06/05/2015
CAMIP23
® , iPad ® , Android
description
12 VDC power supply
connect it to a RJ45 cable
ground wire
connection for external alarm
connection for external alarm
audio input (blue), connection to microphone
audio output (green), connection to speaker
remove the insulating coating and connect to a ground wire to reset
the camera to default setting
® mobile phones
® , Firefox ® , Google™ Chrome and Safari
4
®
©Velleman nv