GRAUPNER PRX-5A Notice D'utilisation page 14

PRX-5A
Power for Receiver
Using the PRX for the first time Using the PRX for the first time
At this point we assume that you have read and absorbed the complete operating instructions,
especially in respect of special notes, characteristics, voltage ranges and battery types.
In the following section we assume that your system incorporates
suitable batteries, and that they are fully charged.
Error states are described in the later section.
1. Select the appropriate battery type using the rotary switch on the PRX.
2. Select the appropriate output voltage by setting the rotary switch on the PRX
(can also be changed when the unit is in use).
3. Connect one battery or two batteries of the same type (as selected) to the PRX
(BAT1 and BAT2), using the adapter leads supplied in the set if necessary.
4. Connect one or both outputs (RX) of the PRX to your receiver.
5. Switch the PRX on (ON). Never connect or disconnect batteries unless the PRX is
switched off (OFF).
6. When the unit is switched on, the LED for the corresponding input lights up green, and
displays a flashing code which indicates the set battery type (BAT1 and / or BAT2).
2 x flashes:
4 x flashes:
5 x flashes:
6 x flashes:
7. When the flashing sequence for the battery type is over, the corresponding LED
(BAT1 and / or BAT2) glows constantly green; if this is not the case, the batteries
connected to it are not fully charged.
8. If the LEDs (BAT1 and / or BAT2) display a different flashing code from those described
above, they are indicating a warning or an error
BAT1
BAT2
OFF / ON
Rotary switch
battery type
two-cell LiFe
two-cell LiPo
five-cell NiMH / NiCd
six-cell NiMH / NiCd or two-cell LiIon
LED BAT1
14
LED BAT2
Rotary switch
output voltage
RX
RX