Publicité
Les langues disponibles
Les langues disponibles
•
DO NOT pull or lift the appliance by the supply cord.
•
DO NOT expose the appliance to humidity or atmosferic agents
(rain, sun, etc.) or extreme temperatures.
• Always disconnect the appliance from the mains supply before
cleaning or performing maintenance and when the appliance is not
in use.
• If the appliance is faulty or malfunctions, switch it off and do not
tamper with it. Contact an authorised technical service centre for any
repairs.
• If the supply cord is damaged it must be replaced by an authorised
technical service centre, so as to prevent all risks.
• When the appliance is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the appliance is
switched off.
• For additional protection, the installation of a residual current device
(RCD) having a rated residual operating current not exceeding 30
mA (ideal 10 mA) is advisable in the electrical circuit supplying the
bathroom. Ask your installer for advice.
•
This appliance shall not come into contact with water, other liquids,
spray, steam. For any cleaning and maintenance operation refer to
the instructions in the relevant chapter.
•
DO NOT use this heater in the immediate surroundings of a bath, a
shower or a swimming pool.
•
DO NOT use this appliance near a washbasin full of water. During
use the appliance must be placed in such a way that it cannot fall in
the washbasin.
• This appliance must not be located immediately below a socketoutlet.
•
DO NOT leave this appliance in contact with or near materials and
surfaces that are easily flammable or can get damaged with heat.
• Use this heater on a horizontal and stable surface, or fix to the wall,
as applicable.
WARNING! In order to avoid overheating, do not cover the
heater.
EN
11
Publicité
