Ametek XEL Serie Mode D'emploi page 52

Step Settings Display
1. O/P off Cal count
2. 0V Cal count
3. Max V, 100mA Cal count
4. Max V, 100mA O/P volts
5. I pot at 0 I pot
6. 2V, 0mA Cal count
7. 2V, 0mA O/P amps
8. 2V, max I Cal count
9. 2V, max I O/P amps
10. 2V, 0mA Cal count
11. 2V, 0mA O/P amps
12. 2V, 500mA Cal count
13. 2V, 500mA O/P amps
14. O/P off 'End'
The Manufacturers or their agents overseas will provide a repair service for any unit developing a
fault. Where owners wish to undertake their own maintenance work, this should only be done by
skilled personnel in conjunction with the service manual which may be purchased directly from
the Manufacturers or their agents overseas.
Cleaning
If the instrument requires cleaning use a cloth that is only lightly dampened with water or a mild
detergent.
WARNING! TO AVOID ELECTRIC SHOCK, OR DAMAGE TO THE INSTRUMENT, NEVER
ALLOW WATER TO GET INSIDE THE CASE. TO AVOID DAMAGE TO THE CASE NEVER
CLEAN WITH SOLVENTS.
52
Adjust for Load
0V ± 2mV DVM
0V ± 2mV DVM
15/30/60V ± 2mV DVM
Display = DVM DVM
Display = 0
0mA ± 0.2mA milli-ammeter
Display = milli-ammeter milli-ammeter
Change load
1.5/3A ± 1mA Ammeter
Display = ammeter Ammeter
0mA ± 0.02mA milli-ammeter
Display = milli-ammeter milli-ammeter
500mA ± 0.1mA ammeter
Display = ammeter ammeter
-
Detail
O/P off volts
V DAC zero
V DAC scale
V metering scale
- I pot ADC zero
High I DAC zero
High I metering zero
High I DAC scale
High I metering scale
Low I DAC zero
Low I metering zero
Low I DAC scale
Low I metering scale
- Stores and exits
Maintenance