Samsung WA45T3400AV Mode D'emploi page 36

Washing a load of laundry
Delay End
You can set the washer to start your wash
automatically at a later time, by choosing a
delay time.
The hour displayed indicates the time at
which the wash will be ended.
1. Set your wash cycle.
2. Press Delay End repeatedly until the
delay time is set.
3. Press START/PAUSE. The "Delay End"
indicator will be lit, and the clock will
begin counting down until it reaches the
set time.
4. To cancel a Delay End function, press the
POWER button and then turn the washer
on again.
Pre Soak
Use this function when the laundry is
heavily contaminated or stained. This
function improves the wash performance by
adding a Pre Soak cycle.
• If you select this function, the total cycle
time is increased by 18 minutes.
• When the Pre Soak cycle starts, the
washer repeats a wash cycle after
supplying water and then performs a
18-minute soak cycle.
• When the Pre Soak cycle is complete,
the configured wash cycle starts without
draining water.
36 English
WA3400T_DC68-03850E-04_EN.indd 36 WA3400T_DC68-03850E-04_EN.indd 36
Smart Care
To enable this function, you must first
download the Samsung Laundry app from
the Play Store or the App Store and install
it on a mobile device that has a camera
function. The Smart Care function has been
optimized for Galaxy and iPhone mobile
devices (applicable models only).
1. When the washer detects an issue to
check, an information code appears on
the display. To enter Smart Care mode,
press Smart Care.
2. The washer starts the self-diagnosis
procedure and displays an information
code if a problem is detected.
3. Run the Samsung Laundry app on your
mobile device, and then tap Smart Care.
4. Put the mobile device close to the
washer's display so that the smartphone
camera and the washer face each other.
The information code will be recognized
automatically by the app.
5. When the information code is
recognized correctly, the app provides
detailed information about the problem
with applicable solutions.
NOTE
• The function name, Smart Care, may
differ depending on the language.
• If the washer's display reflects light,
the app may fail to recognize the
information code.
• If the app fails to recognize the
information code, you can enter the code
manually on the app.
2022-06-30 2022-06-30 12:13:29 12:13:29