Hoover CELDIN 2L360PB Mode D'emploi page 99

18. WATER SOFTENER
UNIT
Depending on the source of the supply,
water contains
limestone and minerals which are deposited
on the dishes leaving whitish stains and
marks. The higher the level of these
minerals present in the water, the harder
the water is.
The dishwasher is fitted with a water
softener unit which, through the use of
special regenerating salt, supplies softened
water for washing the dishes. The degree of
hardness of your water can be obtained
from your water supply company.
Regulating the water softener
Hardness of up to 90°fH (French grading) or
50°dH (German grading) through 6 different
settings. The table below lists different
degrees of water
corresponding setting for the softener unit.
Water
hardness
S0 0-5 0-3
S1 6-15 4-9
S2 16-30 10-16
*S3 31-45 17-25
S4 46-60 26-33
S5 61-90 34-50
* The water softener unit is set in the
factory at level 3, as this is suitable for
the majority of users.
varying amounts
hardness with
No indicator
NO
lights
YES P1
P1+P2
YES
P1+P2+P3
YES
P1+P2+P3+
YES
P4
P1+P2+P3+
YES
P4+P5
According to the degree of hardness of your
of water, regulate the softener unit in the
following way:
The dishwasher must ALWAYS be off
before start of this procedure.
1. Turn on the dishwasher by pressing the
"ON/OFF" button.
2. Press the "Progr." and "ON/OFF"
buttons at the same time, and hold for 5
sec.
3. A short audio signal will sound and all
the indicator lights will flash for 5 sec.
4. The "PROGRAMME
indicator lights will come on to show
lime scale remover levels. If no indicator
the
lights come on, level "S0" will be set.
5. Press "Progr." again to select the
desired level of lime scale removal:
every time you press the button, the
corresponding indicator light will come
on, as shown in the table above
(P1àS1, P2àS2,...) For level "S0", all
the lights will be out.
6. Turn off the dishwasher by holding
down the "ON/OFF" button for 3 sec.
to make the new setting effective.
WARNING!
If any problem occurs, turn the
dishwasher off by pressing the "ON/OFF"
button and start the procedure again
from the beginning (STEP 1).
99
SELECTION"