Publicité
Les langues disponibles
Les langues disponibles
FAULTS
6. On electronic
appliances
without a
display: one or
more indicator
lights flashing
quickly
7. Dishes only
partially washed
8. Detergent not
dispensed or
partially
dispensed
9. Presence of
white spots on
dishes
10. Noise during
wash
11. The dishes
are not
completely dry
CAUSE
Water supply tap turned off
See point 5
Bottom of saucepans have not
been washed well
Edge of saucepans have not
been washed well
Spray arms are partially blocked
The dishes have not been
loaded properly
The end of the drain pipe is
immersed in water
An incorrect amount of detergent
has been measured out, or the
detergent is old and hard
The cap of the salt container is
not closed properly
The wash programme is not
thorough enough
Cutlery, dishes, pans, etc., stop
the detergent dispenser from
opening
Mains water is too hard
The dishes knock against one
another
The revolving arms knock
against the dishes
Inadequate air flow
Rinse aid missing
102
SOLUTION
Switch off the appliance. Turn on the
tap. Re-set the cycle.
Check
Burnt on food remains must be
soaked before putting pans in
dishwasher
Reposition saucepans
Remove spray arms by unscrewing
ring nuts clockwise and wash under
running water
Do not place the dishes too close
together
The end of the drain pipe must not
come into contact with the outflow
water
Increase the measure according to
how dirty the dishes are, or change
detergent
Choose a more vigorous programme
Tighten it properly
Position dishes so as not to obstruct
the dispenser
Check salt and rinse aid level and
regulate. Should the fault persist,
contact the Technical Assistance
Centre
Re-check loading of dishes in the
basket
Re-check loading of dishes in the
basket
Leave the dishwasher door ajar at
the end of the wash program to
allow the dishes to dry naturally
Fill the rinse aid dispenser
Publicité
