Pelgrim GVWC290L Notice D'utilisation page 152

2. Basic settings
The first time the dishwasher is switched on, it is important that you choose the right settings to ensure
good dishwashing results. See page 23.
Set up:
Rinse aid
Water hardness
TAB (All-in-one detergent)
Automatic dosing of detergent
3. Top up with rinse aid
Lift up to open
Press to close
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked MAX.
3. Wipe up any splashes of rinse aid around the compartment.
4. Close the lid firmly.
When the rinse aid needs topping up, the symbol lights on the display.
4. Top up with salt
1. Remove the salt compartment lid by turning it anticlockwise.
2. Place the funnel supplied with the dishwasher in the salt compartment top-up hole. Before washing
for the first time, pour in about 1 l of water. (Water is only needed the first time.)
3. Add enough salt to fill the salt compartment (max. 750 gram). Use special dishwasher salt.
4. Wipe up any excess salt so that the lid can be screwed on firmly.
When the salt needs topping up, the symbol lights on the display.
WARNING!
In order to avoid rust stains a dishwashing program must be started immediately after adding
salt.
8
Drying is faster and a better result is achieved
if you use rinse aid. You will also achieve a
better dishwashing result with clear and
spotless dishes.
Top up the rinse aid compartment with rinse
aid if you have selected Rinse aid 3:01 - 3:05.
For a water supply with a hardness above 5 °dH
(9 °fH / 6 °eH / 0.9 mmol/l), fill with salt.
Add salt to the salt compartment if you have
selected Water hardness 4:01 - 4:09.