FAR R2020IL Manuel D'utilisation page 27

ENGLISH
Changes of the ambient temperature a ect
temperature in the interior of the appliance
so choose a correct setting of the temperature
control knob, depending on your ambient
conditions.
In the STOP (OFF) position the appliance does
not operate (the cooling system is switched o ),
but power supply is not interrupted.
Set the thermostat knob to a middle position to
achieve -18 °C in the freezer compartment.
Please Note:
If the appliance is switched off ou must wait at
least 5 minutes before restarting the appliance
o e-inserting the plug into the wall outlet.
is is to allow the protection device in the
compressor to reset.
If the compressor fails to start correctly remove the
plug and wait for 5 minutes before you try again
then the compressor should restart normally.
e storage temperature may be a ected by:
• e room temperature
• How often the door is opened
• How much food is stored
• Position of the appliance
GB-12
When you set the correct temperature, all these
factors mentioned above shall be taken into
account.
TEMPERATURE INDICATE
In order to help you get the correct adjustment
of your device, it is equipped with a temperature
gauge placed in the coldest area.
For the proper storage of food in
your refrigerator and in particular
in the coldest area, make sure that
«OK» appears in the temperature
indicator.
e symbol on the left side indicates
the location of the coldest area of
your refrigerator. It de nes the
height of this area.
If «OK» is not displayed, the average
temperature in this area will be very high. You
ought to adjust the thermostat to a colder setting.
For every modi cation of your thermostat, you
are supposed to wait for the stabilization of the
temperature inside the unit before proceeding,
if necessary, to a new setting. Do change the
position of the thermostat gradually and wait at
least 12 hours before re-checking.
ENGLISH
GB-13