Aosom B71-055 Mode D'emploi page 6

Safety Pin
WARNING:Do not use the trailer without proper installation of the safety pin.
Installing the Wheels
Steps:
1. Turn the unit on it's back.
2. Slide each Wheel Shaft (A) into the Trailer Axle (B).
3. Press the Lock Button (C) until the Wheel locks into position and cannot be
pulled out. .
4. Repeat for opposite side.
NOTE: To remove the Wheel, push in the Lock Button and pull the Wheel out of the
Axle.
WARNING:
For easy towing and safe handling, check tires often for proper inflation and
Ÿ
wear. Check tire pressure regularly and inflate tires to within the range shown on
the tire sidewall.
Failure to properly install wheels could allow them to come off during use. This
Ÿ
could lead to serious injury.
Attaching the Trailer to Bike
Steps:
(Hitch Connector (9) may be pre-install from the factory)
1. Insert the Hitch Connector (9) into the Hitch Arm (5).
2. Insert Safety Pin (7) and snap Clip Ring (A) over end of Safety Pin as shown.
Hitch Arm
5