Publicité
Les langues disponibles
Les langues disponibles
˜ Emergency off switch
(Fig . J)
In case of an emergency, press the
¾
emergency off switch 7 to stop lifting or
lowering operation .
The product is then locked . To unlock the
¾
product, turn the emergency off switch 7
slightly clockwise (in the direction of the
arrow) until it pops out .
˜ Set-up as block and tackle
Accessories
The following tools are needed for the safe and
proper use of the block and tackle function:
2 spanners (8 mm)
¾
2 spanners (13 mm)
¾
m
WARNING
Do not use any accessories not
u
recommended by Parkside .
Setting up the product as a block and tackle
distributes the load to 2 pulleys . This allows twice
the weight to be lifted . However, the maximum
lifting height and speed are reduced by half .
Fasten the hook 12 to the intended mounting
¾
opening 18 . The steel cable 14 now forms a
loop (Fig . C) .
Dismantle the pulley 11 of the extra hook:
¾
Remove the 3 screws (Fig . F) .
Hang the pulley 11 in the loop formed by
¾
the steel cable 14 (Fig . G) .
Attach the screws and the extra hook 10 to
¾
the pulley 11 . Fasten the 3 screws (Fig . H) .
The block and tackle is now operational
¾
(Fig . I) .
˜ Cleaning and care
m
WARNING!
Disconnect the device from the power supply
before inspections, maintenance or cleaning!
˜ Cleaning
Ensure that no water enters the product
¾
interior .
Regular, proper cleaning helps ensure safe
¾
operation and lengthens the service life of
your product .
Clean the product with a dry cloth . Use a
¾
soft brush for hard-to-reach areas .
NOTE
Do not use any chemical, alkaline,
u
abrasive or otherwise aggressive cleaning
or disinfecting agents to clean the product
as they may damage its surfaces .
GB/IE
21
Publicité
