KitchenAid 5KSM150PSBYP4 Mode D'emploi page 28

Assembling Your Tilt-Head Stand Mixer
To Attach Bowl
1. Turn speed control to "O".
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the
UNLOCK position and tilt motor
head back.
4. Place bowl on bowl clamping plate.
5. Turn bowl gently in clockwise
direction.
To Remove Bowl
1. Turn speed control to "O".
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the
UNLOCK position and tilt motor
head back.
4. Turn bowl counterclockwise.
To Attach Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to "O".
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the
UNLOCK position and raise motor
head.
4. Slip beater onto beater shaft and
press upward as far as possible.
5. Turn beater to right, hooking
beater over pin on shaft.
To Remove Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to "O".
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the
UNLOCK position and raise motor
head.
4. Press beater upward as far as
possible and turn left.
5. Pull beater from beater shaft.
To Lock Motor Head
1. Make sure motor head is
completely down.
2. Place locking lever in LOCK
position.
3. Before mixing, test lock by
attempting to raise head.
To Unlock Motor Head
1. Place lever in UNLOCK position.
NOTE: Motor head should always be
kept in LOCK position when using
mixer.
Pin
O 1 2
To Operate Speed Control
Plug mixer in proper electrical outlet.
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See page 9 for Speed
Control Guide.
5
4 6 8 10