Danby DAC080EUB7GDB Guide D'utilisation Et D'entretien page 14

OPERATING INSTRUCTIONS
USING THE REMOTE CONTROL
8m
Electronic Display
Location of the remote controller
• Use the remote controller within a distance of 8 meters from the appliance, pointing it
towards the receiver. Reception is confi rmed by a beep.
• The air conditioner will not operate if curtains, doors or other materials block
the signals from the remote controller to the indoor unit.
• Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct sunlight,
the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
• If other electrical appliances react to the remote controller, either move these
appliances or call the service depot.
CAUTION
Electronic Display displays the following information:
A: Remote Control power On/OFF and Mode Icons
B: Clock and Auto-Timer settings
C: Current set temperature
D: Fan speed setting control buttons
1. Power switch
Note: The unit will automatically launch the Energy Saver
function when it is in Cool, Dry, and Auto modes.
2. Mode
3. Fan Speed
4. Energy Saver - default setting which allows the fan to cycle on
and off (instead of running continuously) when the compressor
is not in use.
5. Auto-Timer
6. Used to increase or decrease temperature settings in 1° incre-
ments on the Celcius or Fahrenheit scale.
7. Cancels current Timer ON/OFF settings.
8. Lock prevents the remote control settings from inadvertently
being changed.
9. Clock: Depress the button for 3 seconds in order to set the
clock. Press the increase or decrease arrow to adjust the time
in 10 minute intervals.
10. Used to activate the SLEEP program.
11. Toggle the LED backlight on/off.
12. Restore remote control default settings.
NOTE: The clock feature is only available on the remote, the unit
does not have a clock. The remote clock is a 24 hour clock only.
10