Livarno Living 313902 Notice D'utilisation page 7

Congratulations!
With your purchase you have decided on a high-
quality product. Get to know the product before
you start to use it.
Carefully read the following instruc-
tions for use.
Use the product only as described and only for
the given areas of application. Keep these instruc-
tions safe. When passing the product on to a third
party, always make sure that the documentation
is included.
Package contents
1 x wall organiser
1 x perforated plate (1)
2 x storage tray (2)
2 x clip (3)
2 x postcard holder (4)
1 x pen holder, two-part (5)
1 x holding rail (6)
4 x screw (7)
2 x spacer (8)
2 x bracket (9)
2 x bracket with screws (10)
1 x instructions for use
Technical data
Dimensions: 76 x 56 x 10cm (W x H x D)
Intended use
The item is designed for indoor use. The item is
not intended for commercial use.
Symbols used
Date of manufacture (month/year):
02/2019
Safety information
Life-threatening hazard!
• Never leave children unattended with the
packing materials. There is a risk of suffocation!
Risk of injury!
• Ensure the item is properly stabilised before
using it.
• The item may only be used with adult supervi-
sion, and should not be used as a toy.
• The item is not a toy or a climbing apparatus!
Ensure that persons, especially children, do not
pull themselves up on the item or lean against
it.
• Check the item for damage or wear before
each use.
• Never stand or sit on the item.
Assembly
The item can be mounted on the wall or on a
table.
Wall mounting
To mount the item on the wall, proceed as follows:
1. Mark the drill holes using a spirit level at a
distance of approx. 60cm from each other
(Fig. B).
2. Mount the holding rail (6) on the wall using
suitable mounting material.
Note: ask at a specialist store about which
mounting materials (dowel and screws) to use on
your walls.
3. Hang the perforated plate (1) on the holding
rail (6) using two screws (7) (Fig. B).
4. Tighten one screw (7) in each spacer (8) to the
lower edge of the perforated plate (1) (Fig. B).
5. Hook the accessories (2)–(5) to suit your needs
in the perforated plate (1).
Table mounting
To mount the item on the table's edge, proceed
as follows:
1. Fasten the brackets (9), (10) to the perforated
plate as shown in Fig. C.
Note: there are two ways to adjust the distance
between the brackets depending on the thickness
of the tabletop.
2. Attach the perforated plate to the table's edge
(Fig. D).
3. Tighten the screws to the brackets (10).
4. Hook the accessories (2)–(5) in the perforated
plate to suit your needs.
GB/IE 7