Crivit 331497 1907 Notice De Montage page 8

Wheel assembly
1. Insert the pin (10) into the hinge (1d).
The pin should be inserted far enough into the
hinge that the threaded hole and the hole on the
axle rod are exactly above one another (fig. F - G).
2. Now fasten the short screw (7) in the thread-
ed hole (fig. G).
3. The wheel (4) is now pushed onto the pin and
fixed using the washer (8) and the cap nut (9)
(fig. H). Use the included tools for this task.
Sunroof assembly
1. Loosen the pre-mounted locking screws and
the sleeves from the rod (5).
2. Insert the longer screw through the main frame
from the inside to the outside.
3. Attach the sleeve with the wider pipe insert and
fasten the rod with the locking screw (fig. I).
4. The sunroof (3) is fixed in the same way using
the shorter screw and the sleeve with the
narrower pipe insert.
Using as a Transport Aid
To use the article as a transport aid, fold the sun
shade down so that it lies flat on the surface of
the article, and then raise the foot frame (fig. J).
The maximum carrying capacity is 20kg.
Adjusting the Angle
The angle of the backrest can be set to one of
5 levels (fig. K).
Fold the back support completely flat down onto
the seat and then pull up horizontally.
You will hear audible ratchet sounds as you pull
it up, enabling you to select the angle of incli-na-
tion in individual steps.
To reset the angle fold the backrest up past the
vertical and then back down again.
Storage, cleaning
When not in use, always store the product clean and
dry at room temperature. Only clean the product with
a damp cloth and wipe dry afterwards.
IMPORTANT! Never clean the product with harsh
cleaning agents.
Maintenance! Check the bolted connections regularly.
10 GB/IE
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the pack-
aging materials out of the reach of children.
Dispose of the products and the packag-
ing in an environmentally friendly manner.
The recycling code is used to identify
various materials for recycling. The code
consists of the recycling symbol – which is
meant to reflect the recycling cycle – and a
number which identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.
Our service employees will advise as to the
subsequent procedure as quickly as possible.
We will be personally available to discuss the
situation with you.
Any repairs under the warranty, statutory guar-
antees or through goodwill do not extend the
warranty period. This also applies to replaced
and repaired parts. Repairs after the warranty
are subject to a charge.
IAN: 331497_1907
Service Great Britain
Tel.: 0800 404 7657
E-Mail: deltasport@lidl.co.uk
Service Ireland
Tel.: 1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off peak))
E-Mail: deltasport@lidl.ie