Publicité
Les langues disponibles
Les langues disponibles
8.Then open the water faucet of the main water supply, Let the water flow in the
unit. Again press the"TIMER CLEAN"button on control panel for more than 5
seconds, to enter the self-Cleaning program. Same as above explanation, the
water pump runs for 8 minutes and stops for 3 minutes, one cycle, again one
cycle. The total duration time is 30 minutes for one self-cleaning program.
During this process, the "CLEAN"light will always be on during this period, and
the digit window will indicate the left time. Through this process, It will rinse the
water dividing pipe, evaporator, water pump, silicone pipe, and water tank, etc..
9.After one self-cleaning program is completed, then pull out the drain pipe of
the water tank, drain the cleaning solution down to the lower ice storage bin, also
shake the unit slightly to drain out all of the water completely. Then install back
the drain pipe to the water tank slot tightly.
10.Repeat the step 8-9 again for 2 times.
11.Following the above program to clean the ice storage bin .
12.Then this special cleaning program finish, you can return to the regular ice
making mode. And suggest to discard the first batch of ice cube.
Cleaning Suggestion
1)DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned by yourself per
each day. At the end of every day, rinse the ice shovel and wipe the both sides of the
door with a clean cloth.
2)SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate and the surface of the
evaporator are to be cleaned by yourself semi-monthly according to interior cleaning
program.
3)SEMI-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice storage bin,
water tank, door, evaporator, water pump, silicone tube, water dividing pipe, etc.
should be cleaned by Using Nu-Calgon Nickle Safe Ice-machine Cleaner every 6
months. They should be cleaned by the serviceman according to ice making
assembly system cleaning program.
28
NORMAL TROUBLE SHOOTING
Problem
Possible Cause
No water supply
"
"
indicator is on.
Floating ball of the water
level detecting switch is
blocked, can't be raised up
Water flows out from the
water tank
Water flows out from the
water drain pipe of the water
tank.
The unit starts to
enter the ice
making process,
Water supplying hose
but no water
breakdown, or water flows
flowing in the
in very slowly.
unit, and
the "
"
indicator flashes
Water pump is
working, but no
The little holes on the water
water flow out
dividing pipe is blocked.
from the water
dividing pipe
The
transparency
Water quality is bad
of the ice cube
is not very
good
Solution
Check the main water
supply pressure or check
the water supply hose is
blocked or not, adding the
water pressure or cleaning
the hose if necessary.
Clean the water tank and
the water level detecting
switch.
Place the unit on the level
position, not on
the slope.
Pull out the pipe and install
back to the slot
of the water tank properly.
Check the main water
supply pressure or check
the water supply hose is
blocked or not, adding the
water pressure or cleaning
the hose if necessary.
Clean these little holes.
Change the water supply, or
use the water filter to soften
or filter the water.
29
Publicité
