Publicité
Les langues disponibles
Les langues disponibles
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to connect
to water mains and that old hose-sets should not be reused.
1. Connect the water supplying hose to the unit
Step 1: First remove the tape on the water inlet port for water supply (indicated in the
following illustration "B") located at unit back, then use your other hand's finger to press
the out circle.
Step 2: Insert the one end of the white water hose into the water inlet port, and push
inward completely, and install back the clipper, then water hose connection is completed.
STEP 1: Remove the tape
Water inlet port on the unit back
A
Remove the clip first
B
2. Connecting the water drain pipe
Pull out the water drainage cap with black color (indicated A in above
illustration), then connect the white drainage pipe included in accessory, again
connect the other end of this drainage to the main water drainage pipeline.
3. Connect the water hose to the water faucet of the water main supply
system
First, install the supplied water quick-connector to the water faucet by screw
thread; Second, remove the clipper from the water quick-connector, insert
another end of the water hose into this quick-connector port completely, then
install back the clipper, also this step is completed. Note: The water faucet should
be supplied by the customer himself.
18
STEP 2:Insert the water tube
Then install the clip back
White water
tube (accessory)
Insert water tube inward
completely about 0.6 inch
depth
Important: The water pressure of main water supply system must
be 0.04-0.6 MPa at least.
STEP 1 :
STEP 2: Screw the
Quick-connect
quick-connector on
or the water
the water faucet by
faucet
the screw thread,
and remove the
clipper
Remove the
clipper
OPERATING YOUR UNIT
Operation button and display area diagram
Operation of the ice-making process
1.
Plug in the power plug,the
Starting up:
window, press the ON/OFF button on the control panel,the machine will start to
make ice when the external pipe add water to reach the standard level on the
water tank through the electromagnetic water valve, then the
change to light on always in display window and
ambient temperature will be displayed in the upper left of the display window，
"80F"means the ambient temperature is 80
numbers will be displayed in the ambient temperature display area,the flashing
number"10M"means it still needs 10minutes to finish this ice making cycle.
STEP 3: Insert
STEP 4: Install
the water hose
back the clipper
completely
Push
inwards
symbol will flash in the display
symbol will
symbol rotates;The
F,several minutes later,the flashing
O
19
Publicité
