Publicité
5 Instructions de fonctionnement
•
"Er.5" - Auto zero out of range. The message indicates that the
zero condition was not met before beginning a test. This condition
may occur if the measuring fork is briefly loaded and then unloaded
by an outside force during the test sequence. Do not touch the
measuring fork or let anything interfere with the measuring system
while a test is in progress. If this would occur, then the instrument
will display an "Er.5" error message and abort the current test.
This error message may also appear immediately after pressing the Zero
Tensile Display button (Figure 7-1, Item 8) if the Wet Tensile Strength
Tester detects any load disturbance on the measuring fork or the
measuring fork was disturbed and/or mechanically jammed at the time
the Zero Tensile Display button was pressed.
26
Testeur de résistance à la traction humide
man-STC-42112-V17-3 French
Publicité
