Zafferano America Swap Mode D'emploi page 3

swap
Rechargeable table lamp
LD1030B3
1.9"
4.9cm LD1030N3
LD1030R3
*LD1030O3
*Not suitable for outdoor use.
INCLUDED
11.4"
32.5cm
3.9"
10cm
This product contains a class C light source
1. Tips for use:
This product is exclusively for lighting purposes and:
A) It must not be exposed to heavy mechanical loads or contamination; B) It can be installed and used only after checking the state of the product;
check that is not dirty and has not been damaged during storage; C) Installation and maintenance must be carried out when the appliance is switched
off; D) Any alterations to the product, any tampering and any failure to comply with the instructions provided may make the appliance hazardous; E)
When fully assembled, the lamp, reaches an IP65 rating, making it ideal for outdoor use. The lamp placed on the recharging base has an IP20 rating,
making it unsuitable for outdoor use; F) All metal and plastic surfaces should be cleaned with a soft dry cloth; G) The company Zafferano shall not be
held liable for any damage caused due to its products being assembled in any manner that does not comply with the instructions provided.
2. Technical data of the lamp:
- Power: 2 W
- Volt: DC 5 V
- Color temperature: 2200-2700-3000K
- Lumen lamp-LED: 114-168-192lm
- Lithium battery pack included (see section accessories included); for instructions about how to replace the battery pack, please consult the
website: www.zafferanoitalia.com. Use only original batteries for replacement.
- Charge: 6 h
- Battery life: 13 h
- Class: III
- Protection rating: IP65
- CRI>90
3. Battery charger technical data:
- Contact charging base: INPUT/OUTPUT 5Vdc - 1A; cavo USB 1.2 Mt.
- Charger: INPUT AC100-240V 50/60Hz; OUTPUT 5Vdc- 1A.
- The lamp works correctly even when connected to the charging base.
- It is advisable to use the original charger and charging base. Alternatively, you can use a certified 1A max. charger.
4. Important:
- We recommend cleaning using only a soft, dry cloth.
- The support surface for the lamp must not exceed a 15° tilt or it will fall.
- The battery has an overload protection function.
- To preserve the integrity of the battery, we recommend keeping the charge between minimum 20% and maximum 80%; if the lamp is not used for
long periods, it is advisable to regularly charge/discharge the product.
- Please refer to local laws for the proper disposal and recycling of the battery.
DESIGNED BY ZAFFERANO SRL IN ITALY, MADE IN PRC • Imported by Zafferano America LLC, 301 Penhorn Avenue Suite 5 Secaucus, NJ 07094, USA For
more information and updates visit our website • ZafferanoAmerica.com
3
white LED DIMMER
black 2W • 114-168-192lm • 2200-2700-3000K
rust IP65 • 100-240V • 50-60Hz
gold CRI>90 • 5Vdc max 1A
3.9" x 12.8" / 10cm x 32.5cm
NOT INCLUDED
Single-contact
LD0350RP
charging station
Multi-contact
charging base (max. 6 pc)
LD0340RA
Multi-socket USB
charger (8xUSB)
BAT04701906701902
Replacement battery pack
x 2 pz
INSTRUCTIONS FOR USE
SWITCHING ON SWITCHING OFF
Quickly press the touch sensor
Quickly press the touch sensor to
to switch off the lamp.
switch on the lamp.
<1 sec
<1 sec
COLOR TEMPERATURE CONFIGURATION
4 sec <1 sec
2200K
When the lamp is switched off, press lightly Quick tap on the touch sensor
for 4 seconds until a steady blue LED lights to change the color temperature
up of the lamp
CHARGE
Charge the battery before initial use.
To correctly charge the lamp, we recommend that
you:
1) Connect the USB cable to the adaptor;
2) Put the plug into the electrical socket
3) Place the lamp on the charging base;
4) When fully charged, disconnect the plug from the
electrical socket.
INDICATOR LEDS
FLASHING RED LED
PERMANENT RED LED
the battery charge is lower than 20%, charging in progress
charging is recommended.
When the charge is depleted (1%), the lamp
does not switch on but emits three white flashes
as an alert to charge
DESIGNED BY ZAFFERANO SRL IN ITALY, MADE IN PRC • Imported by Zafferano America LLC, 301 Penhorn Avenue Suite 5 Secaucus, NJ 07094, USA For
more information and updates visit our website • ZafferanoAmerica.com
DIMMER FUNCTION
When the lamp is switched on, lightly press
the touch sensor to obtain the
desired brightness. Every time you turn it on,
the light intensity returns to 100%.
<1 sec <1 sec 4 sec
2700K 3000K
Light pressure for 4 seconds to set
the new color temperature and switch off
the lamp
1-2 3
PERMANENT BLUE LED
the battery is 100% charged,
disconnection from the power charger
is recommended
4