Gladiator Garageworks GAWG241DMG Instructions D'assemblage page 3

ASSEMBLY INSTRUCTIONS
Tools and Parts
Check that you have everything necessary for correct assembly.
Proper assembly is your responsibility.
Tools Needed:
e
e
1/2 in. Wrench (GearWall
TM
panel mount)
7A8 in. Wrench (Standard
mount)
• Phillips screwdriver
• 1/4in. Wrench
• 11/_in. Wrench
Parts Supplied for 24 in. (60.96 cm) Cabinet:
• l_-20x11/zin. Lag • 1/4in. Flat washers (4)
screws (4)
Parts Supplied for 30 in. (76 cm) Cabinet:
• Keys (2)
• Full-width shelves (2)
• 1/4 - 20 x 11/2in. Lag
screws (4)
• 1/4in. Flat washers (4)
Cabinet Use Requirements
• Not intended for flammable material storage.
• Intended for use in a garage.
• Maximum weight limit is 50 Ibs (22 kg) for each shelf.
• Maximum weight limit is 200 Ibs (91 kg) for the 30 in. (76 em)
cabinet.
a Maximum weight limit is 150 Ibs (69 kg) for the 24 in.
(60,96 cm) cabinet.
Unpack the Cabinet
I. Open the cabinet door.
NOTE: On the 30 in. (76 em) cabinet you must first remove
the keys and unlock the door.
2. Remove and verify the contents (see "Parts Supplied").
3. Properly dispose of packaging.
Mount the Cabinet to the Wall
Install Cabinet to GearWall
TM
Panels
IMPORTANT: Check to ensure that the GearWalF M panels are
installed with mounting screws in every slot and at every stud
location with a maximum of 24 in, (60.96 cm) horizontally
between screws,
Install 24 in. (60.96 cm) cabinet - 1 mounting bracket
1. Close the cabinet door,
2. Determine cabinet mounting location on GearWa[I
TM
panels.
3. Using 2 or more people, engage the mounting bracket into
the wall slots by lifting up, pushing toward the wall and
lowering the mounting bracket rims into the slots (see
Graphic 1).
4. Make sure the mounting bracket is fully engaged in the slots
(see graphic 2).
Install 30 in. (76 ca) Cabinet - 2 mounting brackets
NOTE: Loosenthe 3 nuts on the bottom mounting bracket just
enough so the mounting bracket will move in the slots,
1. Close the cabinet doors,
2. Determine cabinet mounting location on GearWalFMpanels.
3. Using 2 or more people, engage the top mounting bracket
into the wall slots by lifting up, pushing toward the wall and
lowering the mounting bracket rims into the slots
(see graphic 1).
4. Make sure the top mounting bracket is fully engaged in the
slots (see graphic 2).
5. Open the cabinet doors.
6. From the inside, lift up on the bottom mounting bracket by
the 2 outer bolts until the mounting bracket aligns with the
slots on the GearWall
TM
panel.
7. Push the cabinet toward the GearWalF Mpanel and lower the
bottom mounting bracket rims into the slots,
8. Make sure the bottom mounting bracket is fully engaged in
the slots.
J
j
1 2
I. Mounting brackets
2. Mounting bracketsfuflyengaged.
9. Using a 1/2 in. wrench, tighten the 3 nuts on the bottom wall
mounting bracket,
10. Inspect the cabinet from the sides to ensure both the top and
bottom wall-mounting brackets are fully engaged in their
respective slots as shown.
/
3