Publicité
NOTICE DE MONTAGE:
Enlever les 4 boulons qui fixent la plaque de protection d'origine en place puis enlevez la de la
moto, voir photo 1.
Extraire les 2 entretoises en dehors des 2 supports en caoutchouc avant, voir photo 2.
Dévisser le boulon de fixation supérieur de radiateur du côté gauche de la moto, voir photo 3.
Dévisser de façon à avoir un espace de 2-3mm derrière la tête du boulon pour insérer le support de
protection radiateur.
Couper le bandeau de mousse fourni en pièces de 10mm puis collez-les au bas du cadre de
protection radiateur, de façon à ce qu'elles se placent entre la protection radiateur et le
radiateur.
Monter la grille de protection R&G en position, en veillant à ce que le support supérieur gauche se
place entre le support et la tête du boulon sur le coin supérieur gauche, voir photo 4.
Le coin droit doit s'aligner avec le support indiqué sur la photo 5, qu'un collier peut encercler pour
fixer en place.
Veiller à ce que la grille de protection radiateur soit correctement montées puis placez là-derrière
la moitié inférieure, voir photo 6.
Les supports inférieurs doivent s'aligner avec les 2 trous de fixation inférieurs. Remonter la plaque
de protection, ainsi que les 2 boulons M6 fournis, en veillant à ce que les 2 entretoises, fournies se
placent entre la plaque de protection et les supports de grille de protection radiateur, voir photos 7
& 8.
Réinsérer les 2 boulons de plaque de protection d'origine restants puis serrer.
Serrer tous les boulons de façon égale puis veiller à ce que le radiateur soit correctement monté.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other
services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is
responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall
at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained
otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or neglect.
Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or
consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These
terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G
Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
OUTILS REQUIS
Clé à cliquet + douille 10mm.
Clés Allen 3 & 4mm.
Coupe câble.
ISSUE 1 20/09/2017 (AR)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
