AEG BEK431021M Notice D'utilisation page 15

not clean the glass panels in the
dishwasher.
9. After cleaning, install the glass panels
and the oven door.
If the door is installed correctly, you will hear
a click when closing the latches.
Make sure that you put the glass panels (
and ) back in the correct sequence. Check
for the symbol / printing on the side of the
glass panel. Each of the glass panels looks
different to make the disassembly and
assembly easier.
When installed correctly, the door trim clicks.
A B
Make sure that you install the middle panel of
glass in the seats correctly.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table please
contact an Authorised Service Centre.
Problem
The appliance does not
heat up.
Cause and remedy
The fuse is blown. Make
sure that the fuse is the
cause of the malfunction.
If the problem persists,
contact a qualified electri‐
cian.
12.4 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Problem
The door gasket is dam‐
aged.
The display shows
"12.00".
The lamp does not work.
13.2 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
A
B
Cause and remedy
Do not use the appliance.
Contact an Authorised
Service Centre.
There was a power cut.
Set the time of day.
The lamp is burnt out.
Replace the lamp. Refer
to "Care and cleaning",
Replacing the lamp.
ENGLISH 15