DCO E-mini K5317 Manuel D'utilisation page 24

6.9 PAS sensor direction setting
PAS sensor direction setting interface
6.10 PAS sensor sensitivity setting
PAS sensor sensitivity setting interface
6.11 PAS sensor ratio parameter setting
PAS sensor ratio parameter setting interface
6.12 Speed magnetic steel number setting
Speed magnetic steel number setting interface
About PAS sensor direction setting, the factory default setting is "run-F"
for forward direction. Press the [UP]/[DOWN] button to switch to "run-b",
"run-b" indicates opposite direction. Press the [MODE] button to enter the
next settings interface, press and hold the [MODE] button to save setting
and back to the main interface.
About PAS sensor sensitivity setting, the factory default setting is 2, and the
adjustable range is 2-9.
2 indicates highest sensitivity, 9 indicates lowest sensitivity, press the
[UP]/[DOWN] button to select. Press the [MODE] button to enter the next
settings interface, press and hold the [MODE] button to save setting and
back to the main interface.
About PAS sensor ratio parameter setting, the factory default parameter
is 64, and the adjustable range is 0-255. The larger value indicates that
riders will feel more obvious power assist. Press the [UP]/[DOWN] button
to modify. Press the [MODE] button to enter the next settings interface,
press and hold the [MODE] button to save setting and back to the main
interface.
About speed magnetic steel number setting, the factory default is 1,
indicating that speed magnetic steel number is 1, the adjustable range is
1-9. Press the [UP]/[DOWN] button to select magnetic steel number. Press
the [MODE] button to enter the next settings interface, press and hold the
[MODE] button to save setting and back to the main interface.
24