DCO E-mini K5317 Manuel D'utilisation page 18

3. Installation instructions
Fix the display on the handlebar and adjust the appropriate angle of view. When the e-bike is
powered off, the display can be completed by inserting the connector of the display and the
connector corresponding to the controller.
4. User setting
4.1 Power On/Off
After pressing and holding the [MODE] button, the display starts to work and provides the working
power supply of the controller. In the power on state, press and hold the [MODE] button to turn off the
power supply of the e-bike. In the power off state, the display no longer uses the power supply of the
battery, and the leakage current of the display is less than 1uA.
Full display interface
4.2 Display Normal Interface
Normal display interface
4.3 Walk Assist Mode
Walk assist mode interface
If the e-bike is not used for more than 10 minutes,
the display will power off automatically.
Press and hold the [DOWN] button for 2 seconds
and the e-bike will enter the state of walk assist mode.
The e-bike travels at a constant speed of 6km/h.
The walk assist mode function can only be used when
the user pushes the e-bike. Do not use it when riding.
18