DCO E-mini K5317 Manuel D'utilisation page 23

6.6 Battery capacity value setting
In the battery capacity value setting, users can modify the value represented by each battery bar.
In the P06 VOL interface, press and hold the [UP] and [DOWN] button for 2 seconds, it can enter the
battery capacity value setting interface.
Press the [MODE] button to change position, press the [UP]/[DOWN] button to modify the value.
Press and hold the [MODE] button to save the setting, and press and hold the [MODE] button again to
back to the main interface.
Battery capacity value setting interface
6.7 PAS level range setting
In the PAS level range setting, in the P07 SCR interface, press and hold the [UP] and [DOWN] button for
2 seconds to enter the PAS level range setting interface. The factory default is 0-5, 0 is the lowest PAS
level, 5 is the highest PAS level.
Press the [UP]/[DOWN] button to select 0-3, 1-3, 0-5, 1-5, 0-7, 1-7, 0-9 or 1-9.
After selecting the PAS level range, press the [MODE] button to set each level value.
Press and hold the [MODE] button to save the setting, and press and hold the [MODE] button
again to back to the main interface.
6.8 Controller current limit setting
Each battery bar setting interface
PAS level range setting interface
In controller current limit setting, 16 indicates that the factory default
current limit is 16A. The adjustable parameters are 7A-22A.
Press the [UP]/[DOWN] button to select the current limit value
(increase or decrease by 0.5 per adjustment).
Press the [MODE] button to enter the next settings interface, press and
hold the [MODE] button to save setting and back to the main interface.
23