Tripp-Lite AGAC7579 Mode D'emploi page 3

Mounting (Rack)
2
Adjust each shelf to fit your rack, then mount them in the lowest available space of
your rack with the screws, nuts and washers provided
should face inward. Tighten the wingnuts that connect the shelf segments
3
Attach mounting ears
E
screws provided G . The ears should face forward.
4
Using an assistant, lift your equipment and slide it onto the mounting shelves. Attach
your equipment to the rack by passing the screws, nuts and washers (user-provided)
H through its mounting ears and into the rack rails.
2-Post (Telecom) Mounting
To mount your equipment in a 2-post rack, you must purchase a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKITWM, sold
separately). See the Installation Kit's owner's manual for complete mounting instructions.
Mounting (Tower)
The transformer module can be mounted in an upright tower position when used with optional base stands, sold separately by Tripp Lite
(model: 2-9USTAND). When installing a transformer module, place it between the power module and the battery module.
WARNING!
Transformer modules are extremely heavy! Use caution while lifting and mounting! User must properly stabilize
the module while lifting and mounting!
to the front mounting holes of your equipment
C . Note that the support ledges
D .
F
using the
3
C
2
F
E
3
H
4
D
G