Publicité
Les langues disponibles
Les langues disponibles
Removing the external dust
extraction:
1. Disconnect the suction tube from the
adapter for external dust extraction
(15).
2. Disconnect the adapter for external
dust extraction (15).
Switching the dust
blower function on/off
1. To switch on the dust blower function,
move the switch (24) for the dust blow-
er function to position
2. To switch it off, move the switch (24) for
the dust blower function forward.
Plunge cuts
Plunge cuts may only be made in soft ma-
terials such as wood, aerated concrete,
plasterboard, etc. However, this requires a
certain amount of practice and is possible
only with short saw blades.
Plunge cuts are only allowed if the mitre
angle is 0°.
1. Place the front edge of the baseplate
onto the workpiece surface.
2. Switch the saw on.
3. Slowly saw at an angle into the work-
piece, then bring the saw into a verti-
cal position.
4. Continue sawing along the cutting line.
5. Turn off the saw and lift it off the work-
piece after finishing work.
Working instructions
• Clamp the workpiece. Use a clamping
device for small workpieces.
• Draw a line to specify the direction in
which the saw blade is guided.
• Hold the device securely by the handle.
• Set the sawing speed.
• Adjust the mitre angle.
• Set the pendulum stroke position.
• Turn on the device.
• Wait until the device has reached full
• Place the bottom plate (5) on the work-
• Slowly move the device along the
• Do not apply too much pressure to the
.
• Before shutting down the device, switch
Cleaning and Servicing
Cleaning
speed.
piece.
marked line, pressing the bottom plate
firmly against the workpiece.
device. Let the device do the work.
it off and wait for it to come to a com-
plete standstill.
Switch off the device and re-
move the battery before car-
rying out any maintenance
work.
You should have any repair and
maintenance work that is not de-
scribed in these instructions carried
out by our Service Centre. Only use
original parts.
The device must not be
sprayed with water or placed
in water. Otherwise there is
a risk of electric shock.
Do not use any cleaning agents or
solvents. This could damage the
device irreparably. Chemical sub-
stances may attack the plastic parts
of the device.
GB
IE
31
Publicité
