Publicité
Les langues disponibles
Les langues disponibles
VII.
Testing
１．Inspection before use
A. Check installation of the entire heater and pipe connections
according to the pipe connecting drawing;
B. Check the electric wiring according to the electric wiring diagram;
and grounding connection;
C. Make sure that the main heater power switch is off;
D. Check the temperature setting;
E. Check the air inlet and outlet.
２．Trial
A. The user must start the water pump before the heat pump, and turn
off the heat pump before the water pump, or the heat pump could
be damaged;
B. The user should start the water pump, and check for any leakage
of water. Power the heat pump on by pressing the ON/OFF button
of the heat pump, and set suitable temperature in the thermostat.
C. In order to lower the electrical surcharge, the heater is equipped
with a timer delayed starting function. When starting the heater; the
fan will start 1 minute earlier than the compressor;
D. After the pool heat pump starts up, check for any abnormal noise
from the heater.
VIII.
Precautions
１. Attention
A. Set proper temperature in order to get comfortable water
temperature. Avoid overheating.
B. Do not stack substances that can block air flow near inlet or outlet
area as the efficiency of the heater will be reduced or even stopped.
C. Do not put hands near the water outlet in the swimming pool, and
don't remove the screen of the fan at any time;
13
Publicité
