MOOV FI500 Mode D'emploi page 10

2. Installation and Requirements
The swimming pool heater must be installed by a pool professional. End users are
not qualified to install the heater. Damage may occur to the heater or threaten the
safety of the user. Pool professional guidelines will vary depending on your country,
state or province regulation and can include HVAC technicians or electrici ans.
Warranty will be voided if done otherwise.
A. Installation
1) The swimming pool heater should be installed in a location with good ventilation;
2) The frame must be fixed by bolts (M10) to concrete foundation or brackets. The
concrete foundation must be solid and fastened; the bracket must be strong and
antirust treated;
3) on't stack substances that will block air flow near inlet or outlet area, and no
barrier within 20in behind the main heater, or the efficiency of the heater will be
reduced or even halted;
4) The heater needs an appended pump (Supplied by the user). The recommended
pump specification-flux: refer to Technical Parameter, Max. lift ≥10m;
5) When the heater is running, there will be condensation water discharged from the
bottom. Attach the drainage nozzle (accessory for FI500-FI650-FI900 models) into
the hole under the unit, then connect the pipe to drain the condensation water out.
Ｂ．Wiring
1) Connect to appropriate power supply; the voltage should comply with the rated
voltage of the products.
2) Heater must be grounded.
3) Wiring must be handled by a professional technician respecting circuit diagram.
4) Moov Inverter units do not require a GFCI to function. If required by code, please
respect following guidelines.
Set GFCI according to the local code for wiring (current leakage ≤ 30mA).
i.
ii. Some GFCI breakers may cause nuisance trips with variable speed
products. Consult a certified electrician, your retailer or Moov to confirm
wiring. Product Warranty does not cover electrical wiring.
5) The layout of power cable and signal cable should be orderly and not interfere
with each other.
8