Costway NP11786US Mode D'emploi page 4

FILTER
Press this button to turn the filter pump on and off.
Note: If the heating system is activated, the filtration system will
automatically start.
WARNING: Check if the filter cartridges are installed properly before
starting filtration.
Note: After the heating system turned off automatically or manually,
the filtration system will continue to work for 2 minutes.
Note: In HL mode(see ALARM CODE at the end of the Spa Control
Panel section ), press the FILTER button for 5 seconds to start
forced filtration.
BUBBLE
Press this button to activate the air bubble system(The BUBBLE icon
lights). The air bubble system is designed with a 20-minute auto
shutoff feature. Wait for 10 minutes, after the 20 minute bubbling if
you would like to restart the bubbling again.
CAUTION: Do not run Bubble system when the cover is attached, air
can accumulate inside the spa and cause irreparable damage and
bodily harm.
ALARM CODE - FP
F
C
It means the control base entered the Freeze Protection (FP) mode.
06
How to enter the FP mode: Set the temperature to 68ºF, press the
TEMP DOWN button one more time to enter the freeze protection
mode(FP mode). In the FP mode, all the other icons are unavailable
except the LOCK, TEMP UP and TEMP DOWN. And the water will
be heated to keep the temperature between 41ºF(5ºC) and
50ºF(10ºC).
How to quit FP mode: Press the TEMP UP button until the LED
screen reads 68ºF(20ºC).
Note: The FP function works when the water temperature goes
below 41ºF(5ºC) but over 32ºF (0ºC).
WARNING: DO NOT use the spa when the ambient temperature is
39.2ºF(4ºC）or below.The water temperature might drops below
32ºF(0ºC), in which case the internal pipes of the control box will
freeze.
ALARM CODE - FC
F
C
When the filtering time reaches 168 hours on aggregate, the FC
code flashes on the display panel. At this time, the filter pump will
continue to work, but the filter cartridge need to be replaced
immediately (unplug from the power supply).
In the FC alarm state, except for the FILTER button, others are all
unavailable.
Change the filter cartridge, power on then press the FILTER button
to clear the FC alarm. The filter using time will start calculating again.
ALARM CODE - HL
F
C
When the water temperature is higher than 113ºF(45ºC), HL code
flashes and the buzzer gives an intermittent alarm. In the HL alarm
state, all functions are forced off, and all buttons except FILTER are
invalid. Press and hold the FILTER button for 5 seconds to force the
filter on for 30 seconds. If the HL alarm still continue, please refer to
the Troubleshooting for HL alarm at the end of this manual.
07