Costway NP11786US Mode D'emploi page 3

TEMP UP/DOWN
• Temperature set: After startup, press TEMP UP or TEMP DOWN to
set the desired temperature (LED display reads will flash). Wait for 5
seconds without further operation, the temperature set is done.
After desired temperature set, press the HEATER button to start
heating.
Note: Temperature can be set from 68ºF(20ºC) to 104ºF (40ºC). The
Default temperature is set at 100ºF/38ºC.
• Enter FP(Freeze Protection) mode( see below FP mode
description as below.
LOCK
The spa is designed with child lock function to prevent unauthorized
operation, especially child misusing.
• If no more operation in 10 seconds, the control base will enter the
LOCK mode. In this case all the other buttons will not work. Press
the LOCK button to quit the LOCK mode before proceeding to any
other operation.
• To enter the LOCK mode manually, just press the LOCK button.
04
HEATER
• Press this button to activate the heating system. The pump will
heat the spa water until the water temperature reaches the set
temperature. When the spa water temperature drops around
3.6ºF(2ºC) below the set temperature the heating system will restart.
Note: If the heating system is activated, the filtration system will
automatically start.
Note: After the heating system turned off automatically or manually,
the filtration system will continue to work for 2 minutes (FILTER icon
flashes).
WARNING: Never operate the heating system while the Spa is
empty as this may damage the system.
WARNING: Never operate the heating system when the water
frozen in the spa tub.
IMPORTANT: The following conditions will lead to slow water
heating.
• The ambient temperature is lower than 50ºF(10ºC).
• Outdoor wind speed is above 3.5-5.4 m/s(8-12 mph).
• The air bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water
is heating.
05