Costway FT10002 Mode D'emploi page 4

Make sure you are in good physical condition before using the float
tube.
Do not use this product if you are under the influence of alcohol,
drugs or medication.
Do not exceed your physical capacities.
Do not exceed the maximum load capacity of the float tube, which
includes the weight of the passenger and any equipment on board.
An irregular distribution of loads on the float tube can cause an
imbalance, tipping and hence a risk of drowning. Tell a third party
about your sailing route and schedule.
Adverse weather and marine conditions can be extremely
dangerous; check them before you leave.
Use the product near the coast, and pay attention to natural factors
such as currents, winds, waves, tides and shallows. PAY
ATTENTION TO LAND WINDS AND CURRENTS.
Never use the float in stormy weather.
Check that your float tube is not damaged before each use. If you
notice any irregularities, do not use the product.
Avoid bringing sharp objects into contact with the inflatable tubes.
Inflate to the nominal pressure indicated on the product to avoid risk
of over- inflation and/or explosion.
Refer to local regulations and information regarding hazards for the
float tube and navigation and/or other aquatic activities.
Dress appropriately for weather conditions: cold air and/or cold water
can cause hypothermia.
Wear appropriate clothing (shoes, sun protection, etc.)
Take water and food.
If possible, carry a mobile phone in a waterproof case. Scout out
waters with which you are not familiar, taking your float tube out of
the water and carrying it to avoid any risk.
06
3. USER'S GUIDE
A - Preparation of the float tube
- Taking out the float tube from the bag
- Placing the float tube flat on a clean surface, without objects that
could damage the inflatable structure
- Locating the valves
SEAT: 2 inflation valves at the back of the seat.
SIDE BLADDERS: 2 inflation valves, located on either side of the
bow of the float tube.
- Switch on the low- pressure pump (sold separately) using the
appropriate nozzle. Close the cap again when the inflation is
complete. Do not use an air compressor.
- Inflate the seat and then the side bladders to 0.1 bar /1.5 psi.
- IMPORTANT: Never open the ZIPs on the bladders (used to
replace the bladders) when the product is inflated!
- The boat is ready for launching
B - Maintenance after use
- Rinse the float tube with clean water after each use to avoid
damage from sand, salt water and sunlight.
- Position the float tube vertically to allow water to drain away.
Drying
- Deflate the product
- Let the float tube dry in the open air before folding it. If it was not
dry at the time of folding, make sure to dry it at home, otherwise it
may become mouldy.
NOTE
CAUTION: Never leave the product inflated in direct sunlight! If the
float tube is not used and remains in full sunlight, it can be seriously
damaged. Check the pressure regularly and deflate the float tube
after each use.
07