Publicité
Les langues disponibles
Les langues disponibles
Belt adjustment
1. To ensure optimal performance, it is recommended to turn off the power after 1.5 hours
of continuous use. Allow the machine to rest for 10 minutes before using it again.
2. It is important to adjust the running belt to the appropriate tension. If the belt is too
loose, it may slip while running. If it is too tight, it can hamper motor performance and
increase wear on the drum and running belt. To check the tension is correct, lift both sides
of the running belt from the running board at about 50-75mm.
To adjust the running belt alignment, follow
these steps:
1.Place the electric walking machine on a flat
surface. Set the speed to 6km/h and observe the
deviation of the running belt.
2.If the running belt deviates to the right:
-Unplug the safety lock and power switch.
-Rotate the right adjustment bolt ¼ clockwise.
-Turn on the power switch and press the remote
control start button.
-Observe the deviation of the running belt.
-Repeat the adjustment process until the running
belt is centred (refer to Figure A ).
3.If the running belt deviates to the left:
-Ensure the appliance is off.
-Rotate the left adjustment bolt ¼ clockwise.
-Turn on the appliance and press the start button on
the remote control.
-Observe the deviation of the running belt.
-Repeat the adjustment process until the running
belt is centred (refer to Figure A).
4.After using the walking machine for a long period,
the running belt may gradually relax and require
readjustment:
-Ensure the appliance is off.
-Rotate the left and right adjustment bolts a ¼ clock-
wise.
-Turn on the appliance and press the start button on
the remote control.
-Stand on the running belt to confirm the tightness.
-Repeat the above steps until the running belt is
moderately tight (refer to Figure C).
Publicité
