Philips S9161/41 Mode D'emploi page 24

ENGLISH
24
1 Hold the shaver upside down above the holder. Make
sure the front of the shaver points towards the
SmartClean system.
2 Place the shaver in the holder (1), tilt the shaver
backwards (2) and press down the top cap to
connect the shaver ('click') (3).
, The battery symbol and the on/off button start to
lash, which indicates that the shaver
is charging.
3 Press the on/off button on the SmartClean system to
start the cleaning program.
, The on/off button and the rinsing symbol both light up
continuously.
Note: The rinsing phase takes approx. 10 minutes.
, SmartClean systems Plus only:
During the drying phase, the drying symbol lights up
continuously.
Note: The drying phase takes approx. 4 hours.
, When the cleaning program has been completed, the
ready symbol lights up continuously.
, The battery symbol lights up continuously to indicate
that the shaver is fully charged.
Note: Charging takes approx. 1 hour.
Note: If you press the on/off button of the SmartClean system
during the cleaning program, the program aborts. In this case,
the rinsing or drying symbol stops lashing.