Fanimation FP8003B Serie Mode D'emploi page 14

How to Assemble Your Light Kit Assembly or Cap
1.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2.
Assemble the light plate assembly to the support
bracket using the two key slots in the light plate
assembly. Replace the previously removed screw
and securely tighten all three screws. (Figure 2)
3. Remove the three screws in the light plate
assembly and retain the screws for later. (Figure 3)
4. For use with light kit (A).
Connect the 2 pin connector from the LED kit to the 2
pin connector from motor assembly. (Figure 4)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
5. For use with light kit (B).
Assemble the LED kit to the light plate assembly using
the removed screws in Step 5 and secure all three
screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
Light Plate
Assembly
Motor Assembly
LED Kit
Light Plate
Assembly
LED Kit
14
Motor Assembly
Figure 1
Light Plate
Assembly
Figure 2
Figure 3
Figure 4
Figure 5