Franke FDW 4510 E8P E Manuel D'utilisation page 8

LOWER RACK
For pots, lids, plates, salad bowls, cutlery
etc.... Large plates and lids should ideally be
placed at the sides to avoid interferences
with the spray arm.
(loading example for the lower rack)
The lower rack has a Space Zone A (in selected models with different
numbers and positions), a special pull-out support in the rear of the
rack that can be used to support frying pans or baking pans in upright
position, thus taking up less space.
In order to use it, just get hold of the coloured grip and pull it upwards
B while rotating it forward. The supports can slide right and left to fit
the size of the crockery.
A
The lower rack has tip-up supports which can be used in a vertical po-
sition when arranging plates or in a horizontal position (lower) to load
pans and salad bowls easily.
DAILY USE
1. CHECK WATER CONNECTION
Check that the dishwasher is connected to the water supply and
that the tap is open.
2. SWITCH ON THE DISHWASHER
Open the door and press the ON/OFF button.
3. LOAD THE RACKS
(see LOADING THE RACKS)
4. FILLING THE DETERGENT DISPENSER
5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE
Select the most appropriate program in accordance with the type
of crockery and its soiling level (see PROGRAMS DESCRIPTION) by
pressing the P button.
Select the desired options (see OPTIONS AND FUNCTIONS).
6. START
Start the wash cycle by pressing START/Pause button (led is lit) and
closing the door within 4 sec. When the program starts you hear
a single beep. If the door was not closed within 4 sec., the alarm
sound will be played. In this case, open the door, press START/Pause
button and close the door again within 4 sec.
8
B
CUTLERY BASKET
It is fitted with top grids for improved cutlery arrangement. It must only
be positioned at the front of the lower rack.
Knives and other utensils with sharp edges must be placed in the
cutlery basket with the points facing downwards or they must be
positioned horizontally in the tip-up compartments on the upper
rack.
7. END OF WASH CYCLE
The end of the wash cycle is indicated by beeps and by the flashing
of the wash cycle number on the display. Open the door and switch
off the appliance by pressing the ON/OFF button.
Wait for a few minutes before removing the crockery - to avoid
burns. Unload the racks, beginning with the lower one.
The machine will switch off automatically during certain extended
periods of inactivity, in order to minimise electricity consumption.
If the crockery is only lightly soiled or if it has been rinsed with
water before being placed in the dishwasher, reduce the amount
of detergent used accordingly.