Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION MANUAL
CAA110P
Lock Control Module
The
CAA110P
Lock
reduce installation time and simplify the connection of electromagnetic locks when
used alone or in conjunction with door strikes. The CAA110P Lock Control Module
consists of two onboard, heavy-duty 12V relays, two inputs for alarm contacts and
two relay activation LED indicators. The relays, which are used to control power
to the electromagnetic locks, are toggled by the activation of the controller's lock output
terminals or the CAA110P's alarm contact inputs.
1] INSTALLATION INSTRUCTIONS:
Electromagnetic Lock 1
POWER SUPPLY
Electromagnetic Lock 2
POWER SUPPLY
The
alarm
inputs
for
the
relays
to
lock
outputs
from
above
installation,
to door 1, output LK1 will be enabled in order
to power door strike 1. Relay 1 of the CAA110P
will also toggle, cutting power to electromagnetic
lock 1, thus unlocking the door. Please note
that when a relay is being activated by a
controller's lock output, the appropriate Relay
Activation
LED
2] SPECIFICATIONS:
- No external power source required, relays activated
by a controller's lock outputs.
- Maximum current consumption:100mA @ 12Vdc.
- CTV900A lock output voltage is not to exceed 12Vdc.
- 2 Form C Relays: 12Vdc, 5A contact rating
(with diode flyback protection).
- 2 Alarm inputs:Normally closed contacts
(305m/1000 feet using 22AWG pair).
2
cdvigroup.com
Control
Module
Short contacts
if not used
Alarm contact
for Lock 1
UNLK1 UNLK2
LED 1
Relay 1
LED 2
Relay 2
Relay 2 activation
LED (Green)
must
be
closed
circuits
be
managed
by
the
CT-V900-A!
In
when
access
is
granted
(green)
will
illuminate.
has
been
specifically
Door strike 1
Alarm contact
for Lock 2
Relay 1 activation
LED (Green)
GND
GND
+ 24V
+ 24V
LK1 +
LK1 +
LK1 -
LK1 -
LK2 +
LK2 +
LK2 -
LK2 -
Door strike 2
CTV900A Controller
(Partial view)
- 2 Relay Activation LED Indicators (Green).
the
the
designed
to
The use of an extra
power
recommended when
e l e c t r o m a g n e t i c
JP10 = LK1
locks are used. Set
JP12 = LK2
the
CTV900A
output
12VDC
appropriate
JP10
settings as
12V
LOCK #1
below.
24V
Voltage will damage
JP12
LOCK #2
the unit and void the
12V
warranty.
24V
EN
greatly
source
is
lock
voltage
to
using
the
jumper
shown
Higher
Publicité
