Publicité
Les langues disponibles
Les langues disponibles
en-us_main.book.book Page 10 Wednesday, April 17, 2024 11:49 AM
10 INSTALLATION
3
Fasten the valve cover
Phillips screw
.
g
4
Assemble the valve cover on the refrigerator.
• Assemble the valve cover so it aligns with
the guidelines
and the screw holes in the
A
cabinet. Secure it with a screw
hole.
5
Remove the icemaker fill tube cover.
• Remove the icemaker fill tube opening
cover located on the upper right side of the
refrigerator. Insert the icemaker fill tube all
the way into the opening until it stops.
6
Secure the fill tube.
• After installing the fill tube, secure the top
with 2 screws
where the cover was
b
removed. Then fasten the fill tube to the
cabinet using bands
holes located on the back cabinet, ending
with a screw
in the top right of the valve
b
cover.
to the bracket with 1
k
in the left
b
and screws
in the
e
b
7
Connect to water line.
• To connect to the home water supply, refer
to the Water Line Installation Instructions
within the refrigerator's Owner's Manual.
NOTE
• Once the home water supply line is connected
and turned on, be sure to turn the icemaker
switch to the I (on) position.
• The icemaker will require 12 to 24 hours for ice
to be produced.
• Discard the first few batches of ice prior to using
a batch for consumption.
Publicité
