Costway JB10010 Mode D'emploi page 4

Second: Install the foot pedal
Stepping lever
Fixed screw
Step 1: Loosen the two small fixing screws pre fixed to (6).
Step 2: Install (7) onto (8) using two small fixing bolts.
Third: Connect the back to the seat
Nut
Split pin
1
Step 1: Remove the (2) pre installed bolts and secure the (2) shaft
sleeve and seat shaft sleeve with the bolts
Step 2: Remove the bolts and nuts pre installed on the hydraulic rod,
and fix the rear end of the hydraulic rod to the back with the bolts
and nuts
Step 3: Remove the bolts and nuts on the control lever to the
designated position and reinstall them
06
7
6
Bolt
Nut
Bolt
2
Fourth: Install the armrest
Step 1: Disassemble the bolts and washers pre installed on (5)
and (4)
Step 2: Use the removed bolts and washers to install (5) and (4)
onto (2)
Fifth: Install pillows and pedals
3
Bolt
Step 1: Remove the bolts pre installed under (2) and on (10)
Step 2: Insert (3) according to the position shown in the picture
Step 3: Install (10) and (9) with the removed bolts
Step 4: Install (11) onto (10)
5
2
4
Shim
Bolt
2
10
9
Bolt
11
07