Attach Cleaning Pad; Assemble Power Adapter - ECOVACS ROBOTICS WINBOT950 Mode D'emploi

3. Operating WINBOT
WINBOT is intended to be used for maintenance cleaning on common windows. The product is
not designed to replace heavy-duty or first time cleaning.
Please ensure there is a 15cm (5.9") clearance between the glass and obstacles in the room like
curtains or furniture.
WINBOT can clean horizontally mounted glass but only when using the Direction Control
Buttons on the Remote Control.
WINBOT can clean glass mounted at an angle but may not operate normally; in such a case, a
person should be in the vicinity to assist should there be a problem.
Do not use WINBOT upside down.
Please refer to the glass manufacturer's care and cleaning instructions before using WINBOT on glass
with an uneven surface, such as frosted, textured, patterned, or coated glass. ECOVACS ROBOTICS
cannot be responsible for damage due to improper use on these surfaces.
3.2 Attach the Cleaning Pad
Turn WINBOT over and attach the Cleaning Pad
to the bottom of WINBOT smoothly. The white side
of the Cleaning Pad attaches to the Velcro, and
the gray microfiber side faces out. Make sure the
Cleaning Pad does not cover the Squeegee or Edge
Detection Sensors.
3.3 Assemble the Power Adapter
8
EN