Uline H-7811 Instructions D'assemblage page 2

1. Place the back (1) on a protected surface.
The bottom flange should be facing upward.
(See Figure 1)
Flange faces upward.
NOTE: When bolting the unit together, leave the
bolts slightly loose until step 7, unless otherwise
specified.
2. Attach the left side (2) to the back by placing flange
around the back, and bolting the back and side
together with seven bolts and nuts. Be sure that the
lances on all shelf adjustment strips point in the
same direction. (See Figure 2)
3. Attach the top (7) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the side panel of the unit. The threaded studs
should go through the holes in the top flange of the
side and fasten with three nuts. Attach the back to
the top using four bolts and nuts. (See Figure 3)
PAGE 2 OF 12
CABINET ASSEMBLY
1
2
Flange goes
under back.
All lances point UP on
both back and side.
4. Attach the right side (3) to the back as done in step
2. Make sure the flange is around the back and that
the lances on the shelf adjustment strips are pointed
in the same direction as those on the back and left
side. Push the side panel up so the studs in the top
Figure 1
go through the holes in the top flange of side and
fasten with three nuts. (See Figure 4)
5. Attach the sill (5) to the sides. Place nut loosely on
each of the studs and slide the ends of the sill into
the slots on both sides of the unit. Then, securely
tighten the nuts. (See Figure 5)
Figure 2
6. Place rear flange of the bottom (6) into the bottom
lances of the back and sides. The flange with two
holes should face the front, hanging over the sill.
Insert bolts through the bottom and sill with the head
facing the front of the unit. Secure with two nuts.
Figure 3
(See Figure 6)
7
5
Nuts placed loosely
on sill studs.
Slide ends into slots on
bottom of sides.
6
Figure 4
3
Figure 5
Figure 6
0524 IH-7811