Publicité
Les langues disponibles
Les langues disponibles
Disposal Responsibilities
The equipment you purchased may contain hazardous substances that could impact
the environment. Per regulations on electronic devices in the European Community, you
must use the appropriate disposal systems to avoid exposure of these substances to
the environment. The disposal systems will reuse or recycle hazardous materials from
your equipment responsibly.
The crossed-out wheeled bin symbol invites you to use those systems.
If you need more information on the collection, reuse and recycling systems, please
contact your local or regional waste administration. You can also contact us for more
information on the environmental performance of our products.
Operation
1.
Remove the contents from the package, examining them carefully for
breakage, defects, or missing parts. Save the packaging.
2.
Place Sprout
from the edge of the counter and other moving equipment. Make sure
the power cord is clear of hot surfaces and other hazards.
Warning!
Spin balanced loads only! Do not place the tubes asymmetrically nor load
unequal volume tubes. Improper placement of tubes will lead to insufficient
centrifugation and may cause injury or accident.
3.
Prior to every use, inspect unit for cracks, missing pieces, and or
any damage that would result in an impaired performance and notify
Heathrow Scientific BEFORE use.
4.
Verify that the power switch is in the OFF position. Plug the power
adapter cord into the rear of the unit and the power cord into an
approved outlet. Make sure that the power cord connector can be
readily grasped at the rear of the device so that it can be removed to
easily disconnect it from the centrifuge.
5.
Turn power switch ON. If there is a smooth whirring sound
and the unit accelerates with little or no vibration, Sprout
to use. If there are loud or unusual sounds, or excessive vibration, DO
NOT OPERATE. Contact Heathrow Scientific
6.
On benchtop prepare samples tubes in rack so that tubes are filled to
equal levels. Close tube lids.
7.
To open lid, press down on front latch. The lid will open slightly. Grasp
lid and tilt lid toward rear of unit.
Plus on a sturdy, level surface at least 12" (30cm) away
®
Plus is ready
®
LLC Technical Support.
®
7
Publicité
