Hilti ST 1800 Mode D'emploi page 19

Technical data
For rated voltage, rated current, frequency and/or input power, refer to the country-specific
type identification plate.
If the tool is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the tool. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the tool.
Product generation
Weight
Speed (running under no load)
Max. torque
Chuck
Protection class
Operating temperature
Storage temperature
Noise information and vibration values
The sound pressure and vibration values given in these instructions were measured in accordance
with a standardized test and can be used to compare one power tool with another. They can also be
used for a preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used
for different applications, with different accessory tools, or is poorly maintained, the data can vary.
This can significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is
switched off, or when it is running but not actually being used for a job. This can significantly reduce
exposure over the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration,
for example: maintaining the power tool and accessory tools, keeping the hands warm, organization
of work patterns.
Detailed information on the versions of the EN 62841 standards applied here is to be found in
the reproduction of the declaration of conformity
Noise information
Sound power level (L
Sound pressure level (L
Uncertainty
Vibration information
Triaxial vibration value
Uncertainty (K)
Operation
Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶
Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
*378504*
)
pA
)
wA
378504
ST 1800
01
1.9 kg
0 /min ... 1,900 /min
22 Nm
1
/ " hex socket
4
II
−10 ℃ ... 50 ℃
−30 ℃ ... 70 ℃
134.
87 dB
95 dB
3 dB
2.5 m/s²
1.5 m/s²
14