Publicité
Les langues disponibles
Les langues disponibles
3.
The desired temperature has been reached when the pilot light has turned off. The pilot light will turn
on and off from time to time, indicating that the selected temperature is being maintained.
STEAM IRONING
Steam is regulated by steam knob move to the required position.
Warning: the iron gives off steam continuously only if you hold the iron horizontally. You can stop the
continuous steam by placing the iron in a vertical position or by putting steam knob (4) on
indicated on the thermostat knob, you can only use steam at the highest temperatures. If the selected
temperature is too low, water may drip onto the plate.
BURST OF STEAM
This function provides an extra amount of steam to remove stubborn wrinkles.
Press the burst button to generate a powerful burst of steam that can penetrate the fabrics and smooth the
most difficult and tough creases. Wait for a few seconds before pressing again
By pressing the burst button at intervals you can use also iron vertically (curtains, hung garments, etc.)
Warning: the shot-steam function can only be used at high temperatures. Stop the emission when the
plate temperature control light comes on, than start ironing again only after the light has gone off.
DRY IRONING
1.
Connect the iron to a suitable mains supply outlet.
2.
Ensure that the steam knob (4) is on position
3.
Select the setting with temperature knob.
4.
When the light turns off, the required temperature is reached. The iron is ready for use.
Spray Function
Make sure that there is water in the reservoir. Press the spray button (6) slowly (for a dense spray) or quickly
(for a vaporized spray)
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. In these cases, the Anti-drip system automatically activates
to prevent vaporization, so that you can iron the most delicate fabrics without risk of spoiling or staining them.
SELF-CLEANING
The self-cleaning feature cleans inside the plate, removing impurities.
We recommend using it every 10-15days.
1.
Fill the reservoir up to the maximum level indicated and set the steam button (4)
2. Set the thermostat knob to the maximum temperature and wait for the light to turn off.
3. Hold the iron horizontally over a washbasin or a heat resistant tank, move the steam button cursor to
the left side. Repeat until all the boiling water, steam, and impurities come out.
Cleaning and maintenance
.
8
position. As
Publicité
