Télécharger Imprimer la page

Oceanic OCEASF2000B1 Guide D'utilisation page 23

Publicité

Les langues disponibles

Les langues disponibles

CAUTION: Do not use this unit in a bathroom!
Before using this unit, make sure it is installed on a flat, stable surface. This appliance is
equipped with an anti-tilt switch which stops the appliance in the event of a rollover or if it is not
placed on a stable surface.
Before connecting the power supply cable, check that the operating voltage of the device,
indicated on its nameplate, corresponds to the voltage of your electrical installation (230 volts).
• To turn on the appliance, turn the thermostat knob clockwise (to "MAX"), then turn the
second knob to activate the motor.
When using for the first time, operate the device in ventilation mode "
• Select "
" to activate Ventilation Mode; "I" or "II" to activate Heating Mode according to the
desired temperature:
0 = off
• After reaching the desired room temperature, hold it to turn the "Thermostat" knob
counterclockwise until the indicator light goes out. This temperature will be retained by the
thermostat function.
The heater has a protection system against overheating. If overheating of the unit should occur,
a temperature limit system inside the unit will automatically shut off the power supply to reduce
the risk of fire. The unit may restart as soon as all normal operating conditions and temperatures
are restored. Identify the causes of this overheating to avoid further incidents.
When not using this heater, return the 2 knobs to their initial positions: " 0 " and " MIN.", and
then disconnect the power cable.
Warning:
This product can only be used in well isolated premises or occasionally.
-
Maintenance and cleaning:
Warning: the appliance must be unplugged before cleaning or maintenance.
To clean the outer surface of the unit, use a slightly damp cloth. Then dry with a soft, dry
-
cloth before reuse.
Do not use any detergent, chemical or wax to make the appliance shine as they may react to
-
heat and cause discoloration or fire if the products are flammable.
When the unit is not used for a period of time, make sure it is unplugged from the outlet.
-
Clean it as previously mentioned. Ideally, store it in its carton packaging.
IV. INSTRUCTIONS TO USE
= ventilation
I = hot (1000W)
II = very hot (2000W)
" for a few minutes.
23

Publicité

loading

Ce manuel est également adapté pour:

Oceasf2000